Username: Password:
+-

M1 Carbine Images


Author Topic: 3. Undersized Barrel at Spline Section  (Read 4998 times)

edog

  • Administrator
  • *****
  • Posts: 62
3. Undersized Barrel at Spline Section
« on: October 20, 2012, 12:46:46 AM »
 The outside diameter of the barrel at the bearing surface for the gas cylinder must not be reduced. If reduced, leakage of gas between the barrel and the gas cylinder greatly reduces the power available to operate the weapon. This failure can promote short recoil stoppages. This type of failure is likely from a manufacturing defect. This type of failure would have been addressed when your M1 Rifle was put into service and is very unlikely to be seen today.

 

Featured Video

How to disassemble M1


Recent Posts

Range Report: Tikka T3x CTR 6.5 Creedmoor by edog
Today at 05:07:00 AM

Enjoy Our Free Arcade!


Image Gallery

Latest



M1 Garand Images

Powered by EzPortal